Used the ball joint press for the bolt in the center of your E-Z flex and both the front and rear bolts where there is no shackle, just tightening the nut wouldn't pull the serrations on the bolt thru the hanger. Also did like Hank said, put the grease fittings to the inside, makes it much easier to grease in the future. All of my bushings slid in easily, or just a light tap with a hammer. I also used a wetbolt for the EZ flex hanger, pretty sure those grease fittings are for the pivot of the EZ flex, not for the bolt, but it's been awhile since I installed and I could be wrong about that.
|