View Single Post
Old 05-11-2012, 04:42 PM   #7
Terrydactile
Senior Member
 
Join Date: Oct 2009
Location: Bessemer, Alabama
Posts: 323
I had the same problem and found out I was losing voltage because the wire on the trailer was too small causing a voltage drop. I replaced all the wiring from the junction box at the front all the way back to each magnet. The factory wiring was 14 ga and according to dexter axle was minimum at best for the length of trailer I had. I changed it all out to 10 ga which is a little over kill but its what I had laying around the house. I had an increase in voltage of 2 volts at each magnet. It made a tremendous difference.
__________________
2013 F150 XLT Supercrew EcoBoost
'08 Passport 280BH
Terrydactile is offline   Reply With Quote